Others
What kind of concrete adhesive should be used to resist against over 6,000 pounds of pressure?
It is suggested that our No. 1091 epoxy injection-type concrete adhesive should be used.
What are the reasons causing the creases after brushing the premium varnish?
Maybe the brushed film is too thick or wrong solvent is used.
Why patterns are not presented after spraying the texture finish?
Listed below are possible scenarios:
1.Excessive solvent is added so that the film is overly expanded and the patterns cannot be presented.
2.Damp weather has slowed down the evaporation of solvent that the patterns cannot be presented.
3.Wrong solvent is used. In this case, use benzene or banana oil.
1.Excessive solvent is added so that the film is overly expanded and the patterns cannot be presented.
2.Damp weather has slowed down the evaporation of solvent that the patterns cannot be presented.
3.Wrong solvent is used. In this case, use benzene or banana oil.
What kind of paint should be used to repair the rusted rooftop paint-baking sheet?
Surface treatment: Remove the rusty area and the contaminants attached to the coated surface.
Primer: Apply one layer of 1061H(EP-999-H) HIGH SOLIDS EPOXY COATING .
Finish coat: Two layers of UP-04 vinyl ester coat
Primer: Apply one layer of 1061H(EP-999-H) HIGH SOLIDS EPOXY COATING .
Finish coat: Two layers of UP-04 vinyl ester coat
What kind of paint should be used to present smooth plastering surface for the concrete mixer?
Sandblasting the surface till to SIS Sa 21/2 standard first and then apply the paint according to the following coating procedure:
1.One layer of 75μ No. 1011 inorganic zinc dust primer (IZ-01).
2.Two layers of 75μ No. 1075 epoxy aluminum triphosphate primer (spray the Mist Coat first).
3.Two layers of 30μ UP-04 vinyl ester finish coat.
1.One layer of 75μ No. 1011 inorganic zinc dust primer (IZ-01).
2.Two layers of 75μ No. 1075 epoxy aluminum triphosphate primer (spray the Mist Coat first).
3.Two layers of 30μ UP-04 vinyl ester finish coat.
What will be the coating size for per gallon of inorganic zinc dust paint?
Based on spraying 75μdry film thickness, it depends on the type of the coated target. For example, the plain face steel plate will be about 16M2 and that for the building steel structure, about 14M2.